Carrier Access Network Device Axxius 800 - Manual (Page 282)

5-182 Axxius 800 - Release 2.2
CLI Commands
show
show (ds1)
The show (ds1) command displays settings for DS1s.
Syntax: show {ds1-addr}
Example: show 1:1
SLOT A:
Settings for DS1 1:
Circuit ID: CAC DS1# A:1
Up/Down: DOWN
Framing: ESF
Line Coding: B8ZS
Line Build Out: DSX-1 EQUALIZATION FOR 0-133 ft.(CSU 0dB)
Loop Code Detection:ON
Loopback: OFF
FDL Type: None
AIS Forwarding: Enabled
AIS DS1 List: 2:1, 3:1, 4:1, 5:1
Performance Threshold Settings 15 min. 1 day
unavailable seconds: 0 0
severely errored seconds: 0 0
errored seconds: 0 0
sev. errored frame seconds: 0 0
line errored seconds: 0 0
controlled slip seconds: 0 0
bursty errored seconds: 0 0
degraded minutes: 0 0
total linecode violations: 0 0
total pathcode violations: 0 0
{ds1-addr}
The Controller DS1 addresses are different on the DS3 and DS1 Controller, however the
DS1 address on the services cards does not change with Controller type (DS3 or DS1).
DS1 Address on a DS3 Controller in the form {slot:port:channel}
slot A for the DS3 Controller card.
port Port number, range or all.
channel Channel number, range or all.
DS1 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port}
slot A for the DS1 Controller card, or 1-8 for service cards.
port Port number, range or all.