Carrier Access Network Device Axxius 800 - Manual (Page 293)

Axxius 800 - Release 2.2 5-193
CLI Commands
show
show (router)
The show (router) command displays the settings for the Router card.
Syntax: show {rtr_card-addr}
Example: show 1
SLOT 1:
LMI Settings for Router:
LMI: Disabled
RIP Setting for Router:
RIP Mode Receive: RIP1
RIP Mode Send: RIP1
PPP Authentication/Security Settings for Router:
Authentication by Remote:
Protocol: None
User ID: Local Profile Name
Authentication of Remote:
Protocol: None
Local Security Server:
Type: None
PPP Statistics for Slot-1:
Up/Down x Rx Tx Tx
Remote Name State Time Packets Octets Packets Octets
RemoteUnit DOWN 5m19s 0 0 0 0
SNMP Settings for Router:
SNMP Communities:
Name Address Access
public 0.0.0.0 Read
SNMP Trap Destinations:
Name Address Location
public 0.0.0.0 Local LAN
Name: unknown
Contact: unknown
Location: unknown
DHCP Server/BOOTP Relay Agent Settings for Router:
DHCP: Disabled
DNS Proxy Settings for Router:
Total: 0