Carrier Access Network Device Axxius 800 - Manual (Page 181)

Axxius 800 - Release 2.2 5-81
CLI Commands
set
set (ds1 card)
Use the set (ds1 card) commands to configure DS1 card types. These commands apply to the
Quad DS1/E1 (hardened) and Quad DS1 ADPCM (hardened) service cards.
set (ds1 card) spantype
Use the set (ds1 card) spantype command to set the span type (T1 or E1) on the DS1 type
card. Note: this CLI command is not supported in this release.
Syntax: set {ds1_card-addr} {e1span|t1span}
Example: set 6 e1span
To set the Quad DS1/E1 card in slot 6 to E1 mode.
{ds1_card-addr}
The slot number (1-6) that contains a DS1 type card (Quad DS1/E1 or Quad DS1 ADPCM
service card).
{e1span|t1span}
e1span Enables E1 capability on this card.
t1span Enables T1 capability on this card. (Default)