Carrier Access Network Device Axxius 800 - Manual (Page 389)

Axxius 800 - Release 2.2 8-5
FXO Voice Card
Card Configuration
Card Configuration
The FXO voice card can be configured, to support either FXO loop start or FXO ground
start signaling, with various transmit and receive attenuation options.
CLI Commands
The following commands are used to configure the FXO card. For detailed information
on these commands, see Chapter 5, CLI Commands.
l connect
Creates two-way connections between channels
l disconnect
Removes a connection created by the connect command
l set (fxo)
To setup the voice channels parameters (rx gain, signal, tx gain)
l show (fxo)
Displays the settings (type, signaling, RxGain, TxGain) for the FXO
l status (ds0)
Displays the status (AB bits received, AB bits transmitted, signal, trunk
processing) of the DS0s (AB Bit Monitoring)
l status (fxo)
Displays the status (AB bits received, AB bits transmitted, signal, T1
activity, trunk processing) of the specified FXO (AB Bit Monitoring)