Carrier Access Network Device Axxius 800 - Manual (Page 128)

5-28 Axxius 800 - Release 2.2
CLI Commands
add
add (router-wan) static
Use the add (router-wan) static commands to add static elements on the specified WAN
interface.
add (router-wan) static ip address
Use the add (router-wan) static ip address command to add a static IP address to the table
of learned addresses on the specified WAN interface. This command is typically used in
bridging.
Syntax: add {rtr_card-addr} {"wan-name"} static ip address
{"name"} {ip-addr}
Example: add 3 "LosAngeles" static ip address "Pasadena"
195.168.201.140
The example will add a static IP address, 192.168.201.140, named "Pasadena"
to the tables for the WAN interface named "LosAngeles" on the TSR card in slot
3.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{"name"}
A symbolic name to help remember the purpose of this entry. Maximum of 7 characters and
must be enclosed in quotes.
{ip-addr}
The IP address to add to the learned address table for the WAN, in the form of
xxx.xxx.xxx.xxx, where xxx is between 0-255.