Carrier Access Network Device Axxius 800 User Manual
Page 254

5-154
Axxius 800 - Release 2.2
CLI Commands
set
set (router-wan) gre ip
Use the set (router-wan) gre ip command to configure the GRE tunneling of the IP
protocol for a specified WAN interface.
Syntax:
set {rtr_card-addr} {"wan-name"} gre ip
{all|bynetwork|disable}
Example:
set 3 "LosAngeles" gre ip all
The example will set the WAN interface "LosAngeles" in slot 3, to pass all
packets through a GRE tunnel.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{all|bynetwork|disable}
set (router-wan) gre ipx
Use the set (router-wan) gre ipx command to configure the GRE tunneling of the IPX
protocol for a specified WAN interface.
Syntax:
set {rtr_card-addr} {"wan-name"} gre ipx {all|disable}
Example:
set 3 "LosAngeles" gre ipx all
The example will set the WAN interface named "LosAngeles" in slot 3, to pass
all IPX packets through a GRE tunnel.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{"wan-name"}
The WAN interface to modify. The name must be enclosed in quotes.
{all|disable}
all
Tunnel all packets on this interface to the tunnel destination address.
bynetwork
Tunnel packets based on their destination address by matching GRE
network entries, see add (router-wan) gre network command.
disable
Disable GRE tunneling.
all
Tunnel all packets on this interface to the tunnel destination address.
disable
Disable GRE tunneling.