Carrier Access Network Device Axxius 800 - Manual (Page 286)

5-186 Axxius 800 - Release 2.2
CLI Commands
show
show (fxsPS or fxsPSM)
The show (fxsPS or fxsPSM) command displays the settings for the Single Channel POTS
card without modem (FXS PS) or with modem (FXS PSM).
Syntax: show {fxsPS-addr|fxsPSM-addr}
Example: show 8:1
The example shows settings for the FXS PS card in slot 8.
> show 8:1
SLOT 8:
Settings for FXS: channel 1:
Type: VOICE
Signaling: LS
RxGain: -6 dB
TxGain: -3 dB
{fxsPS-addr|fxsPSM-addr}
In the form of {slot:port}.
show id
The show id command displays the system ID for the Axxius 800.
Syntax: show id
Example: show id
The example shows the ID of a Axxius 800 labeled "Axxius 8001"
Axxius 8001> show id
ID: Axxius 8001
slot Slot number (1-8) that the FXS PS card is located
port Port number is 1.