Carrier Access Network Device Axxius 800 - Manual (Page 291)

Axxius 800 - Release 2.2 5-191
CLI Commands
show
show ntp
The show ntp command displays settings for Network Time Protocol.
Syntax: show ntp
Example: show ntp
NTP Settings:
NTP: Disabled
NTP Server Address: 0.0.0.0
NTP Polling Interval (seconds): 16
NTP Timezone (offset from GMT): 0 hours 0 minutes
show (ocudp)
Use the show (ocudp) to display baud, loopdetect, error correction, switched and enhanced
switched service and secondary channel provisioning.
Syntax: show {ocudp-addr}
Example: show 2:1
SLOT 2:
Settings for OCUDP Port 1:
Up/Down: UP
Baudrate: 56000
Loopdetect Types Enabled:
CSU Non-Latching
DSU Non-Latching
OCU Non-Latching
Error Correction: DISABLE
Secondary Channel: DISABLE
{ocudp-addr}
The {slot:port} address of the OCU-DP card to display.
slot Slot number (1-8) where the OCU-DP is located. If no port is specified,
all ports will be displayed.
port Port number or range.