Carrier Access Network Device Axxius 800 - Manual (Page 245)

Axxius 800 - Release 2.2 5-145
CLI Commands
set
set (router-lan) rip
Use the set (router-lan) rip commands to specify RIP for the specified LAN interface.
set (router-lan) rip ip
Use the set (router-lan) rip ip command to specify the IP RIP for the specified LAN
interface.
Syntax: set {rtr_lan-addr} rip ip {both|neither|recv|send}
Example: set 2:1 rip ip send
The example will set RIP on the local LAN interface on slot 2 to send.
{rtr_lan-addr}
The Router address is in the form {slot:port} or {slot "profile-name"}.
{both|neither|recv|send}
slot The slot number (1-8) that contains the Router card.
port Port number of the Router.
"profile-name" The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
both Enable IP RIP (or IPX RIP and SAP) in both directions.
neither Shut IP RIP (or IPX RIP and SAP) off completely.
recv Enable IP RIP (or IPX RIP and SAP) in the receive direction only.
send Enable IP RIP (or IPX RIP and SAP) in the send direction.