Switch, Switch activeimage, Switch controller – Carrier Access Network Device Axxius 800 User Manual
Page 358: Switch -258, Switch activeimage -258, Switch controller -258, Switch controller c
5-258
Axxius 800 - Release 2.2
CLI Commands
switch
switch
switch activeimage
Use the switch activeimage command to switch the active with the backup application images
stored in a Controller or Router card.
Syntax:
switch [rtr_card-addr] activeimage
Example:
switch activeimage
> switch activeimage
Do you really want to do this? y
OK
[rtr_card-addr] -
The Router card slot number (1 - 8) to retrieve the image information
from. Note: If no slot number is entered, the image information is retrieved from the
Controller.
switch controller
Use the switch controller command to switch to the standby controller.
Note: for redundant Axxius systems only.
Syntax:
switch controller
Example:
switch controller
> switch controller
Do you really want to do this? y
Standby controller not found. Switch Command Canceled!