Carrier Access Network Device Axxius 800 - Manual (Page 490)

18-2 Axxius 800 - Release 2.2
Maintenance
Software Loading
Software Loading
Loading System Software via TFTP
1. Login to the Axxius 800, using a terminal emulation program or via Telnet.
NOTE: The tftp utility provided by Carrier Access with the downloadable
software must be running, in the same directory as the software file.
Command Description
load standby tftp {ip-addr}
"file-name"
CLI command to load software to the Standby
Controller. See the load tftp command for
details.
reset standby
Do you really want to do
this ? Y
Reset the Standby Controller. You will be asked
to confirm this command, answer Y (Yes). See
reset (controller) command for details.
status equipment Check the Standby Controller status, when it
displays hot standby go on to the next step. If hot
standby does not display stop here. If you go
further you may affect service. Start the
process again and if you are not successful call
Customer Service. See status equipment
command for more details.
switch controller Set the signal clock switching. See the set clock
command for details.
Note: You will be disconnected from the unit when switching Controllers. Re-establish
connection with Axxius.
load standby tftp {ip-addr}
"file-name"
CLI command to load software to the Standby
Controller. See the load tftp command for
details.
reset standby
Do you really want to do
this ? Y
Reset the Standby Controller. You will be asked
to confirm this command, answer Y (Yes). See
reset (controller) command for details.