Show (router-lan) stp, Show (router-lan) stp -211 – Carrier Access Network Device Axxius 800 User Manual
Page 311

Axxius 800 - Release 2.2
5-211
CLI Commands
show
show (router-lan) stp
The show (router-lan) stp command displays the current Spanning Tree Protocol settings for
the specified LAN interface.
Syntax:
show {rtr_lan-addr} stp
Example:
show 3:1 stp
> show 3:1 stp
SLOT 3:
LAN Spanning Tree Protocol Settings for LocalUnit:
Spanning Tree: Enabled
Port Cost: 100 seconds
Port Priority: 128 seconds
{rtr_lan-addr}
The Router address is in the form {slot:port} or {slot "profile-name"}.
slot
The slot number (1-8) that contains the Router card.
port
Port number of the Router.
"profile-name"
The profile name for the Router interface. Name must be enclosed in
quotes, with a maximum length of 11 characters.