Set user, Set user -169, Set user comm – Carrier Access Network Device Axxius 800 User Manual
Page 269

Axxius 800 - Release 2.2
5-169
CLI Commands
set
set user
Use the set user command to modify attributes for a specific user that have been created with
the add user command.
set user level
Use the set user level command to set the user access level.
Syntax:
set user {"user-name"} level {1|2|3}
Example:
set user "paul" level 2
{"user-name"}
The user-name is a user ID to add to the system. Text is a single word, with no blank spaces
and must be enclosed in quotes.
{1| 2| 3}
Sets the level of access.
set user password
Use the set user password to set the password for a defined user.
Syntax:
set user {"user-name"} password
Example:
set user "john" password [Enter]
New Password: ****
New Password again: ****
{"user-name"}
The user-name is an existing user ID in the system. Text is a single word, with no blank
spaces and must be enclosed in quotes.
Level 1
Manager has full access to ALL commands. Typically, there is only one
designated user at this level
Level 2
Operator has access to all commands except for the add user
and set user
commands
Level 3
Monitor (read only) has access to commands that display reports and status