beautypg.com

Carrier Access Network Device Axxius 800 User Manual

Page 177

background image

Axxius 800 - Release 2.2

5-77

CLI Commands

set

set(ds0) type

Use the set (ds0) type command to setup one or all DS0s in a DS1 signal type.

Syntax:

set {ds0-addr} type {data|voice}

Example:

set 3:1:1-4 type voice

To set the traffic type to voice on channels 1-4 on port 1 of slot 3 on a service
card.

{ds0-addr}

The Controller DS0 addresses are different on the DS3 and DS1 Controller, however the
DS0 address on the service cards does not change with Controller type (DS3 or DS1).

{data|voice}

DS0 Address on a DS3 Controller in the form {slot:port:channel:sub-channel}

slot

A for the DS3 Controller card.

port

Port number, range or all.

ds1 channel

DS1 channel number, range or all.

ds0 channel

DS0 channel number, range or all.

DS0 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port:channel}

slot

A for the DS1 Controller card, or 1-8 for service cards.

port

Port number, range or all.

channel

Channel number, range or all.

data

Set the DS0 up to carry data (clear channel)

voice

Set the DS0 up to carry voice traffic (robbed-bit signaling)