Carrier Access Network Device Axxius 800 - Manual (Page 188)

5-88 Axxius 800 - Release 2.2
CLI Commands
set
set (fxsPS or fxsPSM)
Use the set (fxsPS or fxsPSM) command to setup voice channels of an Single Channel POTS
card (FXS PS) or the POTS card with modem (FXS PSM). The command specifies the list of
voice channels, and the setting to apply.
Syntax: set {fxsPS-addr|fxsPSM-addr} {setting}
Example: set 3:1 signal ls
To set the port on slot 3 to Loop Start signaling.
{fxsPS-addr|fxsPSM-addr}
Voice channels to apply setting to, in the form of {slot:port}.
{setting}
set id
Use the set id command to the unit ID.
Syntax: set id {"id-name"}
Example: set id "Axxius800"
Axxius800>
{"id-name"}
The name must be unique with a maximum of 20 characters. Name must be enclosed in
quotes.
slot Slot number 1-8, location of the FXS PS or FXS PSM card
port Port number or range
rxgain The receive level range is -12 to +6 (db). Available in .25 dB increments
signal Set the DS0 signaling type
ls Set to Loop Start signaling
lsrb Set to Loop Start signaling with reverse battery
txgain Transmit level range is -12 to +6 (db). Available in .25 dB increments