Carrier Access Network Device Axxius 800 - Manual (Page 195)

Axxius 800 - Release 2.2 5-95
CLI Commands
set
set lsprotect remove
Use the set lsprotect remove command to remove port from protected mode.
Syntax: set lsprotect {slot:port} remove
Example: set lsprotect 5:2 remove
Do you really want to do this? y
*-Protected port(s) not removed since they were not previously
assigned.
Example: set lsprotect 5:2 remove
> set lsprotect 5:2 remove
Do you really want to do this? y
OK
{slot:port}
The {slot:port} address of the protected port to be configured.
slot Slot number (1-8) where a Quad T1 card is located
port Port number or range (1-4)