Carrier Access Network Device Axxius 800 - Manual (Page 465)

Axxius 800 - Release 2.2 15-13
Terminal Server Router Card
Card Configuration
l set (router-wan) dlci
Configure the DLCI for a specified WAN interface that will be using a frame
relay encapsulated trunk.
l set (router-wan) gre
Configure the Generic Routing Encapsulation tunneling for a specified
WAN interface.
l set (router-wan) ip
Set the IP traffic handling on the WAN interface.
l set (router-wan) ip address
Set the IP address for a WAN interface.
l set (router-wan) ipx
Set the IPX traffic handling on the WAN interface.
l set (router-wan) nat
Configure Network Address Translation (NAT) on a specified WAN
interface.
l set (router-wan) other
Set the traffic handling of protocols other than IP or IPX on the specified
WAN interface.
l set (router-wan) ppp
Configure the Point-to-Point Protocol on the specified WAN interface.
l set (router-wan) rip
Set the type or RIP updates on the WAN interface.
l set (router-wan) stp
Configure the trunk port for a specified WAN interface.
l set (router-wan) trunk
Configure the trunk port or multilink group for a specified WAN interface.
l set (router-wan) up/down
Set the specified WAN interface up or down.
l show (router)
Displays the current TSR settings.
l show (router) dhcp
Displays the current DHCP settings for the TSR card.