Carrier Access Network Device Axxius 800 - Manual (Page 210)

5-110 Axxius 800 - Release 2.2
CLI Commands
set
set (router) enhanced security
Use the set (router) enhanced security command to enable or disable enhanced login security
on the TSR. When enabled the user will not receive any login prompt or other output until the
security password is typed. The security password is set via the set (router) password command.
Syntax: set {rtr_card-addr} enhanced security
{disable|enable}
Example: set 5 enhanced security enable
The example will enable the enhanced security on the Router card in slot 5.
Note: A set 5 password security "password" command must be completed
before the enhanced security can be enabled.
See, set (router) password on page 5-114
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{disable|enable}
set (router) lmi
Use the set (router) lmi command to specify the Local Management Interface (LMI) protocol
to use for the specified Router card.
Syntax: set {rtr_card-addr} lmi {annexd|disable|lmi}
Example: set 5 lmi annexd
The example will configure LMI on the Router card in slot 5 to
Annex D.
{rtr_card-addr}
The slot number (1-8) that contains the Router card.
{annexd|disable|lmi}
disable Disable enhanced login security
enable Enable enhanced login security
annexd Set LMI to Annex D.
disable Disable LMI on the TSR.
lmi Set LMI to LMI rev1 (DLCI 1023)