Carrier Access Network Device Axxius 800 - Manual (Page 249)

Axxius 800 - Release 2.2 5-149
CLI Commands
set
set (router-lan) up/down
Use the set (router-lan) up/down command to set the specified LAN interface up or down.
When the Router port is set down, a link failure will not cause an alarm. This can be used to
eliminate alarms from Router ports that are not in-use. When the Router port is set up, a link
failure on the Ethernet port will cause an alarm to be reported to the Axxius 800.
Syntax: set {rtr_lan-addr} {down|up}
Example: set 2:1 down
The example will set the local LAN interface on slot 2 down.
{rtr_lan-addr}
The Router address is in the form {slot:port} or {slot "profile-name"}.
{down|up}
slot Slot number (1-8) that contains the Router card.
port Port number of the Router.
"profile-name" The profile name for the Router interface. Name must be enclosed
in quotes, with a maximum length of 11 characters.
down Set the Router as Out-of-Service. This command turns off the LED and
disables alarm reporting for the Router specified.
up Set the Router as In-Service. This command turns on the LED and
enables alarm reporting for the Router specified.