Carrier Access Network Device Axxius 800 - Manual (Page 331)

Axxius 800 - Release 2.2 5-231
CLI Commands
status
status (ds0)
Use the status (ds0) command to display the current status of the specified DS0.
Syntax: status {ds0-addr}
Example: status a:1:1
Displays the current status of the DS0s on port 1 on slot A
(controller card), port 1, channel 1.
> status a:1:1
DS0 Rx AB Tx AB Signal T1 TP
A:1:1 11 01 EMW Traffic N
Display Descriptions
Rx AB - AB bits received by the FXS or FXO port
Tx AB - AB bits transmitted by the FXS or FXO port
Signal - Signaling mode for which the port is configured
T1 - T1 Status
TP -
Trunk Processing
{ds0-addr}
The Controller DS0 addresses are different on the DS3 and DS1 Controller, however the
DS0 address on the service cards does not change with Controller type (DS3 or DS1).
DS0 Address on a DS3 Controller in the form {slot:port:channel:sub-channel}
slot A for the DS3 Controller card.
port Port number, range or all.
ds1 channel DS1 channel number, range or all.
ds0 channel DS0 channel number, range or all.
DS0 Address on a DS1 Controller or service cards (with DS1 or DS3 controller) in
the form {slot:port:channel}
slot A for the DS1 Controller card, or 1-8 for service cards.
port Port number, range or all.
channel Channel number, range or all.