Carrier Access Network Device Axxius 800 - Manual (Page 464)

15-12 Axxius 800 - Release 2.2
Terminal Server Router Card
Card Configuration
l set (router) reboot
Set automatic reboot after an upload of code or configuration file.
l set (router) rip
Specify version of RIP packets to transmit and receive.
l set (router) snmp
Set the SNMP contact, location, name on the router.
l set (router) stp
Set the Spanning Tree Protocol on the router (card).
l set (router) syslog
Set the router to send alarm and event messages to a Syslog server.
l set (router-lan) filter forward
Set the forwarding mode for Layer 2 filters on the LAN interface.
l set (router-lan) gateway
Specify a default IP gateway for the specified LAN interface.
l set (router-lan) ip address
Specify an IP address for the specified LAN interface.
l set (router-lan) ipx network
Specify an IPX address for the specified LAN interface.
l set (router-lan) phy
Specify the Ethernet PHY (physical specifications) speed and mode.
l set (router-lan) rip
Specify IP RIP for the LAN interface.
l set (router-lan) stp
Specify the Spanning Tree Protocol on the LAN interface.
l set (router-lan) up/down
Set the LAN interface up or down.
l set (router-trunk) encapsulation
Specify the encapsulation to use on the TSR interface.
l set (router-trunk) multilink group
Specify a router trunk to be part of a multilink PPP group.
l set (router-trunk) up/down
Set the TSR trunk up or down.