4 digital inputs, 1 terminal assignment/electrical data, 2 parameter setting – Lenze E94ARNE Regenerative power supply User Manual
Page 94: Digital inputs, Terminal assignment/electrical data, Parameter setting, Digital inputs ( 94)
9400 regenerative power supply module | Parameter setting
I/O terminals
Digital inputs
94
L
EDS94ARNExxxx EN 2.3 - 06/2014
5.4
Digital inputs
The regenerative power supply module is equipped with 8 freely configurable digital
inputs.
Control input RFR of terminal strip X5 for controller enable is permanently connected
to the device control.
5.4.1
Terminal assignment/electrical data
5.4.2
Parameter setting
Short overview of parameters for the digital inputs:
Terminal
Use
Electrical data
X5/DI1
X5/DI8
Digital input 1 ... 8
LOW level: 0 ... +5 V
HIGH level: +15 ... +30 V
Input current: 8 mA per input
(at 24 V)
Interference-voltage-
proof:
max. ±30 V
Conversion rate: 1 kHz
X5/RFR
Controller enable
See digital inputs
X5/GI
Reference potential (digital ground)
X5
GI
RFR
DI1
DI2
DI3
DI4
DI5
DI6
DI7
DI8
Parameter
Information
Dig. input x: Terminal polarity
Status: Digital inputs
Status word: Digital inputs
Digital inputs: Delay time
Highlighted in grey = display parameter