beautypg.com

35 prepare firmware update, Prepare firmware update – Lenze E94ARNE Regenerative power supply User Manual

Page 77

background image

EDS94ARNExxxx EN 2.3 - 06/2014

L

77

9400 regenerative power supply module | Parameter setting

Device interface

Device commands

4.1.35

Prepare firmware update

Only possible when the controller is inhibited and the application has been stopped.

Possible status displays for this device command

Note!

For Lenze service only!
The

C00002

= "10000: Prepare firmware update" device command serves to set

the regenerative power supply module to the firmware update mode to carry

out a possibly required update of the firmware using the corresponding

software.

Status (

C00003

)

Meaning

655394050 Device command in process

655360000 Device command executed successfully

655360001 General fault

See also other documents in the category Lenze Software: