4 operation, 1 selecting the variables to be recorded, Operation – Lenze E94ARNE Regenerative power supply User Manual
Page 175: Selecting the variables to be recorded

EDS94ARNExxxx EN 2.3 - 06/2014
L
175
9400 regenerative power supply module | Parameter setting
Oscilloscope
Operation
7.4
Operation
This chapter describes step-by-step how to record the signal characteristics of variables in
the regenerative power supply module and represent, analyse, document and process
them in the oscilloscope.
7.4.1
Selecting the variables to be recorded
The oscilloscope supports up to eight channels, i.e. max. eight variables can be recorded in
a data record. Use the Vertical group box to select the variables.
How to select a variable for recording:
1. Go to the Variable column in the Vertical group box and double-click the yellow
field to open the Select variable dialog box.
2. Select the variable to be recorded from the list field.
3. Click OK.
• The dialog box is closed and the selection is accepted.
4. Repeat steps 1 ... 3 to select up to seven more variables to be recorded.
Of course, it is possible at any time to change or delete a selection later.
How to change a selection:
1. Go to the Vertical group box and double-click the variable to be changed in the
Variable column.
2. Select a new variable in the Select variable dialog box.
3. Click OK.
• The dialog box is closed and the selection is accepted.
Note!
Settings can only be selected and recording can only be started in the
oscilloscope when the regenerative power supply module is connected online.