Lenze E94ARNE Regenerative power supply - Manual (Page 225)

EDS94ARNExxxx EN 2.3 - 06/2014
L
225
9400 regenerative power supply module | Parameter setting
Diagnostics & fault analysis
Error messages
Control card is defect (UB18 neg.) [0x00780008]
Control card is defect (VCC5) [0x00780009]
Electronic nameplate: Data are incompatible [0x0078000a]
Incorrect device command transfer [0x00790000]
Time error - controller interface [0x00790001]
Violation of time slice [0x00790002]
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Device error Please contact Lenze.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The connected filter with feedback is not supported by
the device firmware.
Check device dimensioning.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error If the error occurs frequently, please contact Lenze.