Lenze E94ARNE Regenerative power supply - Manual (Page 37)

EDS94ARNExxxx EN 2.3 - 06/2014
L
37
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1 Device commands
The following subchapters describe the device commands of the regenerative power
supply module, which are available in C00002 and which can be executed using the keypad
or via the »Engineer« when an online connection has been established.
Activating frequently required device commands via the toolbar
Frequently required device commands can be executed very easily directly via the Toolbar
of the »Engineer« when an online connection has been established.

Note!
Before switching off the supply voltage after a device command has been
executed, check via the status display in C00003 that the device command has
been executed successfully!
The meaning of the status display in
C00003 can be obtained from the
subchapter for the corresponding device command.
Icon Function
Enable controller
Inhibit controller
Start application
Stop application and Inhibit controller

Note!
Device commands that can be executed via the Toolbar of the »Engineer« always
affect the element that is currently selected in the Project View and all
subelements!
• If, for example, a system module is selected in the Project view instead of the
regenerative power supply module, the corresponding device command will
be activated in all lower-level regenerative power supply modules &
controllers that are currently connected online with the »Engineer«.
Before the corresponding action is executed, a confirmation prompt is displayed
to ask you if this action should really be carried out.