Lenze E94ARNE Regenerative power supply - Manual (Page 326)

9400 regenerative power supply module | Parameter setting
Parameter reference
Parameter list | C01124
326
L
EDS94ARNExxxx EN 2.3 - 06/2014
C01124
C01125
C01126
Parameter | Name:
C01124 | Sync-PLL increment
Data type: UNSIGNED_8
Index: 23451
d
= 5B9B
h
If the cycle times of the synchronisation signal and the phase-locking loop (PLL) deviate from each other, this setting
defines the increment by which the phase-locking loop can be corrected.
• For the system bus (CANopen) as synchronisation source, the recommended time setting in the case of occurring
deviations is 109 ns.
 "CAN on board" system bus: sync telegram
Selection list (Lenze setting printed in bold)
1 7 ns
2 15 ns
3 23 ns
4 31 ns
5 39 ns
6 46 ns
7 54 ns
8 62 ns
9 70 ns
10 78 ns
11 85 ns
12 93 ns
13 101 ns
14 109 ns
15 117 ns
16 125 ns
17 132 ns
18 140 ns
19 148 ns
20 156 ns
21 164 ns
22 171 ns
23 179 ns
24 187 ns
25 195 ns
26 203 ns
27 210 ns
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C01125 | Service code
Data type: UNSIGNED_32
Index: 23450
d
= 5B9A
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C01126 | Service code
Data type: UNSIGNED_32
Index: 23449
d
= 5B99
h
This code is used internally by the device and must not be overwritten by the user!