Lenze E94ARNE Regenerative power supply - Manual (Page 88)

9400 regenerative power supply module | Parameter setting
Device interface
Display of output and regenerated energy
88
L
EDS94ARNExxxx EN 2.3 - 06/2014
4.6 Display of output and regenerated energy
This function is available from software version V2.0 onwards!
The following parameters display the energy of the regenerative power supply module
output at the DC side and the energy fed back to the mains:
 The display values are stored in the memory module with power failure protection and
are therefore even available after device replacements.
 The display values can be reset to zero via the following device commands ( C00002 ):
– 65: Reset transmitted energy
( 61)
– 66: Reset regenerated energy
( 62)
Parameter Information Lenze setting
Value Unit
C00145/1 Output energy, DC side - kWh
C00145/2 Regenerated energy - kWh
Highlighted in grey = display parameter

Note!
The kWh display does not completely replace a three-phase meter!