Lenze E94ARNE Regenerative power supply - Manual (Page 133)

EDS94ARNExxxx EN 2.3 - 06/2014
L
133
9400 regenerative power supply module | Parameter setting
"CAN on board" system bus
Diagnostics
6.8 Diagnostics
Via the display parameters listed in the following table, current states and actual values of
the system bus can be queried for diagnostic purposes, e.g. by using the keypad, a bus
system or the »Engineer« (when an online connection to the device has been established).
 In the »Engineer« parameter list and in the keypad, these parameters are grouped in
the CAN  CAN management category.
 For a detailed parameter description, please see the chapter " Parameter reference ".
( 265)
Parameter Display
C00345 CAN error
C00359 CAN status
C00360/1 CAN stuffing bit error counter
C00360/2 CAN format error counter
C00360/3 CAN acknow. error counter
C00360/4 CAN bit 1 error counter
C00360/5 CAN bit 0 error counter
C00360/6 CAN CRC error counter
C00360/7 CAN Tx telegram counter
C00360/8 CAN Rx telegram counter
C00361/1 CAN bus load: current node load in Tx direction
C00361/2 CAN bus load: current node load in Rx direction
C00361/3 CAN bus load: current node load of faulty telegrams
C00361/4 CAN bus load: node peak load in Tx direction
C00361/5 CAN bus load: node peak load in Rx direction
C00361/6 CAN bus load: node peak load of faulty telegrams
C00390 CAN error register (DS301V402)