Lenze E94ARNE Regenerative power supply - Manual (Page 329)

EDS94ARNExxxx EN 2.3 - 06/2014
L
329
9400 regenerative power supply module | Parameter setting
Parameter reference
Parameter list | C01215
C01215
C01217
C01220
C01221
C01222
C01223
Parameter | Name:
C01215 | Set time and date
Data type: UNSIGNED_16
Index: 23360
d
= 5B40
h
Setting of the device's system time displayed in C01214 .
• If the MM440 memory module with real-time clock is plugged into the regenerative power supply module, the
real-time clock is set simultaneously.
Set time and date.
• Before writing to a subcode for the first time, the current time of the internal clock is displayed in the subcodes.
• When a subcode has been overwritten, the display in the subcodes freezes to the last values.
• The reset system time is only accepted after each subcode has been overwritten at least once.
• After the new system time has been accepted, the display in the subcodes is updated according to the internal
clock.
Note:
If a memory module without real-time clock is plugged into the regenerative power supply module, the internal
clock is initialised with "01.01.1970 00:00:00" every time the power is switched on.
Setting range
(min. value | unit | max. value)
0 65535
Subcodes Lenze setting Information
C01215/1 0 Seconds
C01215/2 0 Minutes
C01215/3 0 Hours
C01215/4 0 Day
C01215/5 0 Month
C01215/6 0 Year
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C01217 | Service code
Data type: VISIBLE_STRING
Index: 23358
d
= 5B3E
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C01220 | Service code
Data type: UNSIGNED_32
Index: 23355
d
= 5B3B
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C01221 | Service code
Data type: UNSIGNED_32
Index: 23354
d
= 5B3A
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C01222 | Service code
Data type: UNSIGNED_32
Index: 23353
d
= 5B39
h
This code is used internally by the device and must not be overwritten by the user!
Parameter | Name:
C01223 | Service code
Data type: UNSIGNED_32
Index: 23352
d
= 5B38
h
This code is used internally by the device and must not be overwritten by the user!