32 archive parameter sets 1, Archive parameter sets 1 – Lenze E94ARNE Regenerative power supply User Manual
Page 73

EDS94ARNExxxx EN 2.3 - 06/2014
L
73
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.32
Archive parameter sets 1 ... 4
In addition to the start parameters, up to four more parameter sets can be stored in the
memory module for each application. This, for instance, serves to define different
controller settings for an application, which can then be simply activated via device
command.
The following device commands can be used to archive the current parameter settings of
the regenerative power supply module as parameter sets 1 ... 4 for the active application in
the memory module:
= "301: Archive parameter set 1"
= "302: Archive parameter set 2"
= "303: Archive parameter set 3"
= "304: Archive parameter set 4"
[4-10] Example: "Archive parameter set 1" function
Previously archived parameter settings will be overwritten with the current parameter
settings!
* In this example application 1 is the active application
PS 4
PS 3
PS 2
Application 2
PS 1
PS
PS 4
PS 3
PS 2
Memory module MM
PS
9400
PS
RAM
Firmware
Application 1*
Application 1*
PS
PS 1