Yokogawa DAQWORX - Manual (Page 321)

8-64 IM WX104-01E
Seral Communcaton Settngs
When using serial communications between the CX and other devices, set the
parameters required for serial communications. In the [Protocol] settings, if [MODBUS
MASTER] is selected, you must to click the [Modbus master] tab and make Modbus
master settings.
Click this tab
Modbus Master Settngs
When using the CX as a Modbus master, enter the Modbus master basic and command
settings. For details about the settings.
Click this tab
8.11 Network Settngs