Aux (automatic message, display position), Aux (automatic message, display position) -39, Index – Yokogawa DAQWORX User Manual
Page 296: Aux (automatc message, dsplay poston)

8-39
IM WX104-01E
1
2
3
4
5
6
7
8
9
Index
Conf
gur
ng the CX1000/CX2000
AUX (Automatc Message, Dsplay Poston)
Turn message display ON/OFF, and set the loop display position on the CX.
Message displays on the CX trend display screen
Auto change to program run display (style number S3 or later)
Display position when loop display on the CX is partitioned
Tag display (settings cannot be entered here)
Tag comment display (settings cannot be entered here)
Auto message
If you select [On] (initial setting), a message is automatically written on the trend display
when program control is started and when program control is stopped as shown in the
figure below. If you do not wish to write messages, select [Off]. The message when
starting program operation is “PROGRAM RUN”; the message when stopping the
program operation is “PROGRAM RESET.”
Position
On the program selection display and program control display, the specified patterns and
PV waveforms can be displayed in the same display frame (full display) as well as display
data by dividing the display position per loop (split display). When using split display,
select the display position number from [1] to [6] for each loop. On Style 3 or later, the
value can be set on the loop whose Action Loop Set is ON. On Style 2 or earlier, the
value can be set on loops whose [Control Mode] has been set to a mode other than [Off]
and [Program Control] to [On] in [Internal Loop] under the [Setup] tab. During cascade
control, even-numbered loops within the same terminal block cannot be set.
Auto change to program run display (style number S3 or later)
You can set the screen to switch to the Program Control Display when a program
execution command is received using the communication function.
ON:
When a program execution command is sent, the screen switches to the Program
Control Display.
OFF: The screen does not switch to the Program Control Display even when a program
execution command is sent (default).
8.6 Program Control Related Setup Operatons