Yokogawa DAQWORX - Manual (Page 162)

6-35 IM WX104-01E
1
2
3
4
5
6
7
8
9
Index
Conf
gur
ng the DX1000/DX2000
• Date format
Settngs Dsplay Example
Y/M/D 2005/11/30
M/D/Y 11/30/2005
D/M/Y 30/11/2005
D.M.Y 30.11.2005
Appled Range
The format is applied to the date displayed on the screen. It does not change the
date format on the setup screen of the date/time, the date in the output data via
communications, the date saved along with the data, and the date used in the data file
names.
• 1st weekday (Release number 3 or later)
This setting specifies how to display the calendar that you use to search past
measured data. You can set the first day of the week to Sunday or Monday.
• Servce port
The following table indicates the number of simultaneous uses (number of users that
can use the function simultaneously), the maximum number of connections, and the
port number for each function.
Functon Maxmum Number
of Connectons Number of
Smultaneous Uses
Admnstrator User Port Number
FTP server 2 2 2
*1
21/tcp
*3
Web server – 80/tcp
*3
SNTP server – 123/udp
*3
Modbus server 2 502/tcp
*3
Instrument information server – – – 34264/udp
*2
*1 There are user limitations. For details, see the DX1000/DX1000N/DX2000 Communication
interface User’s Manual (IM04L41B01-01E).
*2 The port number is fixed.
*3 The default port number. You can set the value in the range of 1 to 65535. Use the default
port number unless there is a special reason not to do so.
• Status Relay
In the [System Configuration] screen, if [FAIL] is set to [FAIL/Alarm relay] (/F2 option)
or [FAIL/Status relay] (/F1 option), the [Status Relay] setting items are displayed.
Fal Relay, Status Relay (Release numbers 4 and later)
For this function, there are relays labeled “FAIL” and “Status” on the rear panel. You
can assign operations to these two relays. On a relay that has been set to “Status
relay,” you must also set the DX status that will be relayed (see below).
Memory/Meda Informaton, Measurement Error, Communcaton Error,
Memory Stop, Alarm
The relay contact output is turned on when an item that is set to [ON] occurs. [Alarm]
is available in release numbers 3 and later.
6.5 Enterng Basc Settngs