Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 294)

show policy capability
9-8 Policy Classification Configuration
show policy capability
Use this command to display detailed policy classification capabilities supported by your D‐Series
device.
Syntax
show policy capability
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
Use this command to display detailed policy classification capabilities supported by your D‐Series
device. The output of this command shows a table listing classifiable traffic attributes and the type
of actions, by rule type, that can be executed relative to each attribute. Above the table is a list of
all the actions possible on this device.
The left‐most column of the table lists all possible classifiable traffic attributes. The next two
columns from the left indicate how policy profiles may be assigned, either administratively or
dynamically. The next four columns from the left indicate the actions that may be performed. The
last three columns indicate auditing options.
An x in an action column for a traffic attribute row indicates that your system has the capability to
perform that action for traffic classified by that attribute.
ST Whether or not this rule’s storage type is non-volatile (NV) or volatile (V).
VLAN VLAN ID to which this rule applies and whether or not matching packets will be
dropped or forwarded.
CoS If applicable, Class of Service value to which this rule applies.
U Whether or not this rule has been used.
dPID Whether or not this is a dynamic profile ID.
aPID Whether or not this is an administrative profile ID.
Table 9-34 show policy rule Output Details (Continued)
Output Field What It Displays...