Enterasys Networks Enterasys D2 D2G124-12P - Manual (Page 152)

show port protected
4-48 Port Configuration
Example
This example shows how to assign ports ge .1.1 through ge .1.3 to protected port group 1:
D2(rw)->set port protected ge.1.1-3 1
show port protected
Use this command to display information about the ports configured for protected mode.
Syntax
show port protected [port-string] | [group-id]
Parameters
Defaults
If no parameters are entered, information about all protected ports is displayed.
Mode
Read‐only.
Example
This example shows how to display information about all protected ports:
D2(ro)->show port protected
Group id Port
----------------------
1 ge.1.1
1 ge.1.2
1 ge.1.3
clear port protected
Use this command to remove a port or group from protected mode.
Syntax
clear port protected [port-string] | [group-id]
Parameters
Defaults
If no parameters are entered, all protected ports and groups are cleared.
port‐string (Optional) Specifies the port or ports for which to display information.
group‐id (Optional) Specifies the id of the group for which to display information.
Id can range from 0 to 2.
port‐string (Optional) Specifies the port or ports to remove from protected mode.
group‐id (Optional) Specifies the id of the group to remove from protected mode.
Id can range from 0 to 2.