Dell PowerEdge VRTX - Manual (Page 199)

199
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 4/ 1 8 /1 3 - F O R PR O O F O N LY
Working with the Active Image File Using CLI Commands
The following table summarizes the CLI commands for viewing fields
displayed in the Active Images .
The following is an example of the CLI commands:
Copy Files
Use the Copy Files page to perform the following:
• Copy the firmware on the device to another, specified file.
• Copy the master Running Configuration file to the Startup Configuration
file, or vice versa.
• Copy the master Startup Configuration file to a backup file on the Flash
file system.
• Copy a configuration file to the Running Configuration file. It is
important to be aware that copying a file to the Running Configuration
file actually executes these commands, so some of the configuration
commands might fail (for example when trying to create a VLAN that is
already defined on the system).
• Restore configuration factory defaults.
To copy files or restore factory defaults:
1 Click System > File Management > Copy Files in the tree view to display
the Copy Files page.
2 To copy the Running Configuration file of the device to the Startup
Configuration file of the device or vice versa, select Copy Configuration
Firmware and enter the options:
–
Source — Select either the Running Configuration or the Startup
Configuration file.
Table 6-56. Active Image CLI Commands
CLI Command Description
boot system {image-1
| image-2}
Sets the system image that the device loads at
startup.
show version [md5]
Displays version information for the system
console# boot system image-1 all