Dell PowerEdge VRTX - Manual (Page 117)

117
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 4/ 1 8 /1 3 - F O R PR O O F O N LY
To add an IPv6 neighbor:
1 Click System > IP Addressing > IPv6 Neighbors in the tree view to
display the IPv6 Neighbors: Summary page.
The previously-defined neighbors are displayed along with their states.
The possible states are:
–
Incomplete — An address resolution is in progress, and the link-layer
address of the neighbor has not yet been determined.
– Reachable — The neighbor is known to have been reachable recently
(within tens of seconds).
– Stale — The neighbor is no longer known to be reachable, but until
traffic is sent to the neighbor, no attempt is made to verify its
reachability.
– Delay — The neighbor is no longer known to be reachable, and traffic
has recently been sent to the neighbor. Rather than probe the
neighbor immediately, however, there is a delay sending probes for a
short while, in order to give upper-layer protocols a chance to provide
reachability confirmation.
– Probe — The neighbor is no longer known to be reachable, and
Unicast Neighbor Solicitation probes are being sent to verify
reachability.
2 To clear the Neighbors table, select one of the following options:
– None — Does not clear any entries.
– Static Only — Clears the static entries.
– Dynamic Only — Clears the dynamic entries.
– All Dynamic and Static — Clears the static and dynamic address
entries.
3 To add a new IPv6 neighbor, click Add, and enter the fields:
– IPv6 Interface — Displays the interface on which the IPv6 address is
defined.
– IPv6 Address — Enter the neighbor IPv6 address.
– MAC Address — Enter the MAC address assigned to the interface.