Dell PowerEdge VRTX - Manual (Page 290)

290
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSwitching_STP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
The default path costs assigned to an interface vary according to the
selected method:
Bridge Settings
–
Priority (0-61440 in steps of 4096) — Enter the bridge priority value.
When switches or bridges are running STP, each is assigned a priority.
After exchanging BPDUs, the device with the lowest priority value
becomes the Root Bridge. The default value is 32768. The port
priority value is provided in increments of 4096. For example, 4096,
8192, 12288, etc.
– Hello Time (1-10) — Check to use the device Hello Time, which is
the interval of time in seconds that a root bridge waits between
configuration messages. Enter a value.
– Max Age (6-40) — Check to use device Maximum Age Time, which is
the time interval in seconds that a bridge waits before sending
configuration messages. Enter a value.
– Forward Delay (4-30) — Check to use device forward delay time,
which is the interval of time in seconds that a bridge remains in a
listening and learning state before forwarding packets. Enter a value.
Designated Root — Displays the following:
–
Bridge ID — The bridge priority and MAC address.
– Root Bridge ID — The root bridge priority and MAC address.
– Root Port — The port number that offers the lowest cost path from
this bridge to the Root Bridge. This is significant when the Bridge is
not the Root.
– Root Path Cost — The cost of the path from this bridge to the root.
– Topology Changes Counts — The total amount of STP state changes
that have occurred.
Interface Long Cost Short Cost
LAG 20,000 4
1000 Mbps 20,000 4
100 Mbps 200,000 19
10 Mbps 2,000,000 100