Dell PowerEdge VRTX - Manual (Page 103)

103
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 4/ 1 8 /1 3 - F O R PR O O F O N LY
Defining IPv4 Interfaces Using CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the IPv4 Interfaces Parameters page.
The following are sample procedures to configure a static IPv4 address on an
interface using CLI and then to remove it:
Table 6-17. IPv4 Interface Parameters CLI Commands
CLI Command Description
ip address ip-address {mask |
prefix-length}
no ip address [ip-address]
Sets an IP address.
Use the no form of the command to
remove an IP address.
show ip interface [interface-
id]
Displays the usability status of
interfaces configured for IP.
ip address dhcp
no ip address dhcp
Acquires an IP address on an Ethernet
interface from the Dynamic Host
Configuration Protocol (DHCP).
Use the no form of this command to
release an acquired IP address.
Table 6-18. Sample CLI Script to Configure IPv4 Statically on a VLAN
CLI Command Description
console#config
Enter Global Configuration
mode.
console(config)# interface vlan 1
Enter Interface mode for
VLAN 1.
console(config-if)# ip address
10.5.225.40 /27
Set the routing interface with
prefix length of 27.
console(config-if)# ip default-
gateway 10.5.225.33
Set the address of the default
gateway
console(config-if)# no ip address
Remove the address (if
required).