Dell PowerEdge VRTX - Manual (Page 392)

392
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSwitching_DHCP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
– Type — Select the entry type. The possible options are:
•
Static —IP address was statically configured.
• Dynamic —IP address was dynamically configured.
– MAC Address — Enter the MAC address to be recorded in the entry.
– VLAN ID — Select the VLAN ID to which the IP address is
associated in the entry.
– IP Address — Enter the IP address to be recorded in the entry.
– Interface — Select the type and port or LAG to be recorded in the
entry.
– Lease Time — If the entry is dynamic, enter the amount of time that
the entry will be active in the DHCP Database. If there is no Lease
Time, check Infinite.
Configuring DHCP Snooping Binding Database Using CLI Commands
The following table summarizes the CLI commands for configuring the
DHCP Snooping Binding database .
Table 17-5. DHCP Snooping Binding Database CLI Commands
CLI Command Description
ip dhcp snooping database
no ip dhcp snooping database
Enables the DHCP Snooping
binding database file.
Use the no form of this command
to delete the DHCP Snooping
binding database file.
ip dhcp snooping database update-
freq seconds
no ip dhcp snooping database
update-freq
Enables the DHCP Snooping
binding database file.
Use the no form of this command
to delete the DHCP Snooping
binding database file.
ip dhcp snooping binding mac-
address vlan-id ip-address
interface-id expiry
{seconds|infinite}
no ip dhcp snooping binding mac-
address vlan-id
Configures the DHCP snooping
binding database and adds
binding entries to the database.
Use the no form of this command
to delete entries from the binding
database.