Dell PowerEdge VRTX - Manual (Page 81)

81
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L CO N F I D E N T I A L – P R E L I MI N A RY 4/ 1 8 /1 3 - F O R PR O O F O N LY
– Offset — The estimated offset of the server's clock, relative to the
local clock, in milliseconds. The host determines the value of this
offset, using the algorithm described in RFC 2030.
– Delay — The estimated round-trip delay of the server's clock, relative
to the local clock over the network path between them, in
milliseconds. The host determines the value of this delay, using the
algorithm described in RFC 2030.
2 To add an SNTP Server, click Add, and enter the fields:
– Supported IP Format — Select whether IPv4 or IPv6 format is used
for the IP address of the SNTP server.
– IPv6 Address Type — When the server supports IPv6, this specifies
the type of static address supported. Select one of the possible
options:
•
Link Local — A Link Local address that is non-routable and used
for communication on the same network only.
• Global — A globally unique IPv6 address; visible and reachable
from different subnets.
– Link Local Interface — When the server supports an IPv6 Link Local
address, this specifies the Link Local interface. Select one of the
possible options:
•
VLAN — The VLAN on which the IPv6 interface is configured.
• ISATAP — The IPv6 interface is configured on an ISATAP
tunnel.
– SNTP Server — Enter the SNTP server’s IP address.
– Poll Interval — Enable/disable polling the selected SNTP server for
system time information, when enabled.
– Encryption Key ID — Check to use an encryption key, and select one
of the encryption keys that was defined in the SNTP Authentication
pages.