Dell PowerEdge VRTX - Manual (Page 176)

176
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
Configuring Communities Using CLI Commands
The following table summarizes the CLI commands for setting fields in the
Community pages.
The following is an example of the CLI commands:
SNMP Notification Filter
Notification filters determine the type of SNMP notifications that are sent to
the management station, based on the OID of the notification to be sent.
Each OID is linked to a device feature or a feature aspect.
SNMP notification filters provide the following services:
• Identification of management trap targets
• Trap filtering
• Selection of trap generation parameters
• Access control checks
Table 6-50. SNMP Community CLI Commands
CLI Command Description
snmp-server community community-
string [ro | rw | su] [ipv4-
address | ipv6-address] [mask
mask | prefix prefix-length]
[view view-name]
no snmp-server community
community-string [ip-address]
Sets up the community access string
to permit access to the SNMP
protocol.
Use the no form of this command to
remove the specified community
string
snmp-server community-group
community-string group-name
[ipv4-address | ipv6-address]
[mask mask | prefix prefix-
length]
Sets up community access string to
permit limited access to the SNMP
protocol, based on group access
rights.
show snmp
Displays the current SNMP device
configuration.
console (config)# snmp-server community dell ro
10.1.1.1