Dell PowerEdge VRTX - Manual (Page 154)

154
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
2 Enter the default parameters for TACACS+ servers. These values are used
unless values are added in the TACACS+ Add or Edit pages.
–
Source IP Address — The device IP address used for the TACACS+
session between the device and the TACACS+ server. The default is
0.0.0.0., which means that any IP address of the device can be used to
communicate with the TACACS+ server.
– Key String (0-128 Characters) — The authentication and encryption
key for TACACS+ communications between the device and the
TACACS+ server. This key must match the encryption key sent by the
TACACS+ server. This key is encrypted.
– Timeout for Reply (1-30) — The amount of time that passes before
the connection between the device and the TACACS+ server times
out.
3 To add a TACACS+ server, click Add, and enter the fields on the page.
The fields below are those that were not described on the TACACS+:
Summary page.
–
Host IP Address — Enter the TACACS+ server IP address.
– Priority (0-65535) — Enter the order in which the TACACS+ servers
are used if several are defined.
– Source IP Address — Enter either specific device IP address for the
TACACS+ server.
– Key String (0-128 Characters) — Enter the key of the TACACS+
server.
– Authentication Port (0-65535) — Enter the port number through
which the TACACS+ session occurs.
– Timeout for Reply (1-30) — Enter the amount of time that passes
before the connection between the device and the TACACS+ server
times out.
– Single Connection — Check to maintain a single open connection
between the device and the TACACS+ server.
Wherever available, check Use Default to use a value that was entered in
the TACACS+: Summary page.