Dell PowerEdge VRTX - Manual (Page 166)

166
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSystemConfig.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
Setting SNMP Global Parameters Using CLI Commands
The following table summarizes the CLI commands for setting fields in the
Global Parameters page.
Table 6-46. SNMP Global Parameters Commands
CLI Command Description
snmp-server engineID local
{engineid-string | default}
no snmp-server engineID local
Specifies the local device engine ID. The
field values is a hexadecimal string. Each
byte in hexadecimal character strings is two
hexadecimal digits. Each byte can be
separated by a period or colon. The Engine
ID must be defined before SNMPv3 is
enabled.
Use the no form of this command to
remove the configured engine ID.
snmp-server engineID remote
{ip-address} engineid-string
no snmp-server engineID
remote {ip-address}
Specifies the remote device engine ID. The
field values is a hexadecimal string. Each
byte in hexadecimal character strings is two
hexadecimal digits. Each byte can be
separated by a period or colon. The Engine
ID must be defined before SNMPv3 is
enabled.
Use the no form of this command to
remove the configured engine ID.
snmp-server enable traps
no snmp-server enable traps
Enables the router to send Simple Network
Management Protocol traps.
Use the no form of the command to disable
SNMP traps.
snmp-server trap
authentication
no snmp-server trap
authentication
Enables the router to send Simple Network
Management Protocol traps when
authentication fails.
Use the no form of this command to
disable SNMP failed authentication traps.
show snmp
Checks the status of SNMP
communications.