Dell PowerEdge VRTX - Manual (Page 284)

284
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Plasma\User
Guide\Plasma_UGSwitching_GARP.fm
D E L L C O N F ID E N T IA L – P R E L IM I N A RY 4 / 1 8 /1 3 - F O R P R O O F O N LY
GARP Timers
To enable a GARP timer on an interface:
1 Click Switching > GARP > GARP Timers in the tree view to open the
GARP Timers: Summary page.
The GARP timers are displayed.
2 Click Edit.
3 Select an interface, and enter the fields:
– GARP Join Timer (10 - 2147483640) — Enter the time, in
milliseconds, during which Protocol Data Units (PDU) are
transmitted.
– GARP Leave Timer (10 - 2147483640) — Enter the time interval, in
milliseconds, which the device waits before leaving its GARP state.
Leave time is activated by a Leave All Time message sent/received,
and cancelled by the Join message received. Leave time must be
greater than or equal to three times the join time.
– GARP Leave All Timer (10 - 2147483640) — Enter time interval, in
milliseconds, which all devices wait before leaving the GARP state.
The leave all time must be greater than the leave time
.
Defining GARP Timers Using CLI Commands
This table summarizes the CLI commands for defining GARP timers as
displayed in the GARP Timers pages.
Table 10-1. GARP Timer CLI Commands
CLI Command Description
garp timer {join|leave|leaveall}
timer_value
no garp timer
Adjusts the GARP application join,
leave, and leaveall GARP timer val-
ues.
Use the no form of this command to
restore the default configuration.