Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 771)

Chapter 30
Using a 9/Series Dual--Processing System
30-31
Figure 30.14
Backup Interference Boundary Screen
TO
PORT A
TO
PORT B
TO
FILE
STORE TO BACKUP
INTERFERENCE TABLE
5. Determine the destination for the G10 program:
To Send the G10 Program To: Press This Softkey: Go to Step:
peripheral attached to port A {TO PORT A} 7.
a peripheral attached to port B {TO PORT B} 7.
to control memory {TO FILE} 6.
6. Press the
{TO FILE}
softkey. The control asks for a program name.
By using the alphanumeric keys on the operator panel, enter the
program name you wish to call the backup program . Press the
[TRANSMIT]
key once you have entered the program name. See
chapter 10 on program names. The G10 program is saved under the
file name just entered.
7. Press the
{TO PORT A}
or
{TO PORT B}
softkey. A
{YES}
or
{NO}
softkey is displayed. Press
{YES}
to confirm or
{NO}
to abort. If you
confirm the operation, the G10 program is written to a peripheral
attached tot he selected port.