Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 688)

Paramacros
Chapter 28
28-14
Example 28.11
Assigning Using More Than One I, J, K Set
G65P1001K1I2J3J4J5;
The above block sets the following parameters:
parameter #6 = 1
parameter #7 = 2
parameter #8 = 3
parameter #11 = 4
parameter #14 = 5
If the same parameter is assigned more than one value in an argument, only
the right-most value is stored for the parameter.
Example 28.12
Assigning the Same Parameter Twice
G65P1001R3.1A2R-0.5
The above block sets the following parameters:
parameter #1 = 2.0 As set by the A--word
parameter #18 = -0.5 As set by the last R--word.
The 1st value of 3.1, assigned to parameter #18 by the R--word, is
replaced by the 2nd value set by the second R--word.
Example 28.13
Assigning The Same Parameter Twice Using I, J, and K
G65P1001R2I3.4D5I-0.6
The above blocks set the following parameters:
parameter #18 = 2 As set by the R--word.
parameter #4 = 3.4 As set by the 1st I--word.
parameter #7 = -0.6 As set by the 2nd I--word.
The 1st value of 5, assigned to parameter #7 by the D--word,
is replaced by the 2nd value set by the second I--word.