Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 51)

Basic Control Operation
Chapter 2
2-29
Table 2.E (continued)
Password Protectable Functions
Parameter Name: Function becomes accessible when parameter name is in reverse video:
22) SI/OEM MESSAGE ·{ENTER MESSAGE} — Enter a new message to be displayed on the control’s power-up screen.
·{STORE BACKUP} — Store an entered message for the power-up screen to backup memory.
23) SCALING When SCALING is not in reverse video, the operator still has access to the {SCALNG} softkey; however
values on the screen may not be modified.
24) CHANGE
DIRECTORY
Allows access to the protectable directory for file edit, direct execution selection, and encrypted output.
25) AUX COMM Allows access to the {AUX COMM} softkey that sets Data Highway Communication Module Parameters.
26) SEARCH MONITOR Allows access to the {SEARCH MONITOR} softkey that allows searching and monitoring of the
control’s PAL program.
27) PASS THRU ENABLE Allows access to the {PT ENABLE} softkey that enables remote I/O pass thru of AMP, PAL, and other
ODS features. The {PT ENABLE} softkey is only available when AMP is configured to disallow block
transfers and the system contains remote I/O hardware that has been enabled through PAL.
When you power-up, only functions that are not protectable and functions
that are assigned to access level 8 are available (provided that the active
level when power was turned off was not assigned the POWER UP
LEVEL feature). To access the functions that are assigned to a specific
access level, you must enter the password that corresponds to that access
level. To enter a password, follow these steps:
1. Press the
{PASSWORD}
softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2.7.3
Entering Passwords