Rockwell Automation 8520 9/Series CNC Lathe - Manual (Page 147)

Editing Programs On Line
Chapter 5
5-41
This section describes making a duplicate of a part program in control
memory. To input or output a part program from/to a peripheral device,
see the sections on inputting or outputting programs in chapter 9.
To copy part programs stored in memory using different program names:
1. Press the
{PRGRAM MANAGE}
softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the
{COPY PRGRAM}
softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
DELETE
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
3. Key in or cursor down to the program name of the program to be
copied.
4. Key in a comma followed by the a new program name for the
duplicate program.
COPY: FROM_NAME,TO_NAME
5. Press the
{MEM TO MEM}
softkey.
MEM TO
PORT A
PORT A
TO MEM
MEM TO
PORT B
PORT B
TO MEM
MEM TO
MEM
(softkey level 3)
This message appears:
“FROM: (source program name)
“TO: (new programs name)
5.9
Copying Programs
{COPY PRGRAM}